RICARDO R20
Model R4100D Type In-line,4 Cycle No. Of Cylinder 4 Bore*Stroke (mm) 100 x 115 mm Ttl. Displacement 3.61 litres Induction system naturally aspirated Rated Out-put 30 KW Rated Speed Mechanically governed 1500 rpm Fuel Consumption 25% load 2.8 -- 50% 4.3 -- 100 % 8.5 Oil Capacity 13 Litres Cooling Method Positive Water Cooling Cycle Starting Method D.C 12 V electric starting
Model Wattek WHI184F Rated Power 20KW - 25 kva Rated Voltage 400 - 415 3 - phase Rated Current 36 amps per phase 3 phase Rated Frequency 50HZ Rated Speed 1500 RPM Power Factor 0.8 lagging for 3-phase Phase Connection 3-phase Winding Connection 3 or 4 -wire connected(12-wire for 3-phase) Excitation Method Brushless Voltage Regulation AVR
Control Panel Smartgen 6120 controller, Power switch/key starter, main circuit breaker, Buzzer Alarm and Lamp switch 3 Phase Electricial Sockets (on Generator) complete with circuit breakers 1 x 15amp socket single phase 1 x 20 amp -- 3 phase 56series 1 x 32 amp -- 3 phase 56series 1 x 63amp 5 pin International socket Central lifting eye & forklift pockets / enclosed in a low noise insulated Canopy, Canopy is galvanized steel plate and then is powder coated. 400 - 415 3 - Phase / 230 -240 Single Phase Bunded Fuel Tank Standard size 150 Litres, other sizes available Fuel Tank Run Time 34 hours on 50% Load -- 17 hours on 100% Load Approx Gross net weight 950kg Approx Packing Size L x W x H (mm) 2100 x 850 x 1230 Noise Level -- Decibels @ 7 m 70-72
This generator also has the below features.
- Canopy is Galvanized steel plate and then is powder coated.
- Canopy is weatherproof
- all external bolts are stainless steel.
- All sockets are IP67. Weatherproof
- Bunded Fuel tank
- Battery isolating switch
- Pump for changing the oil
Shutdown Protection
- Emergency Stop
- High temp shutdown
- Low oil pressure shutdown
- Overspeed shutdown
- Underspeed shutdown
- Loss of speed signal shutdown
- genset over Voltage shutdown
- genset over Current shutdown
- Failed to start
- Over freq Shutdown
- Temp Sensor Open
- Oil sensor open
- Input Shutdown
- Over Power
- Low water sensor
Going Fully Automatic
All of our generators are partnered with a Smartgen 6120 controller system this gives the user the option of going fully automatic.
To go fully automatic add ATS & AMF HAT520 Transfer box depending on the size your electrician would only need to run the wiring between the generator, transfer box and the main switchboard. And when you lose power the generator would auto start and when the power returns the generator would auto shutdown. Note: The Transfer Box is not waterproof