POWERED BY:
CUMMINS C30 KW
| Model | 4BT3.9-G1 |
| Type | In-line,4 Cycle |
| No. Of Cylinder | 4 |
| Bore*Stroke (mm) | 102 x 120 |
| Ttl. Displacement | 3.9 |
| Induction system | Turbocharged |
| Rated Out-put | 36KW |
| Rated Speed | Engines fitted electronic governor, 1500 rpm |
| Fuel Consumption | 25% load 4 -- 50% 5.9 -- 100 % 10 |
| Oil Capacity | 11 Litres |
| Cooling Method | Positive Water Cooling Cycle |
| Starting Method | D.C 24 V electric starting |
| Model | Stamford PI144J |
| Rated Power | 30KW - 38kva |
| Rated Voltage | 400 - 415 3 - phase / 230 - 240 single phase |
| Rated Current | 54 amps |
| Rated Frequency | 50HZ |
| Rated Speed | 1500 RPM |
| Power Factor | 1 for single phase / 0.8 lagging for 3-phase |
| Phase Connection | 1-phase or 3-phase |
| Winding Connection | 3 or 4 wire connected (12-wire for 3-Phase) |
| Excitation Method | Brushless |
| Voltage Regulation | AVR |
| Control Panel | Smartgen 6120 controller, power switch/ key starter, main circuit breaker, buzzer alarm and lamp switch |
| Electrical Sockets (Generator) Complete with circuit breakers | 1 x 15amp socket single phase - 1 x 20amp - 3 phase 56 series 1 x 32amp - 3 phase 56 series 1 x 63amp 5 pin international socket |
| Central Lifting eye & forklift pockets / enclosed in a low noise insulated canopy. Canopy is galvanized steel plate and then is power coated. | 400 - 415 3 - Phase / 230 -240 Single Phase |
| Bunded Fuel Tank Standard size | 150 Litres, other sized available |
| Fuel Tank Run Time | 39 Hours on 50% load - 21 Hours on 100% load |
| Approx Gross net weight | 1200 Kg |
| Approx Packing Size L x W x H (mm) | 2280 x 950 x 1500 |
This generator also has the below features.
- Canopy is Galvanized steel plate and then is powder coated.
- Canopy is weatherproof
- all external bolts are stainless steel.
- All sockets are IP67. Weatherproof
- Bunded Fuel tank
- Battery isolating switch
- Pump for changing the oil
Shutdown Protection
- Emergency Stop
- High temp shutdown
- Low oil pressure shutdown
- Overspeed shutdown
- Underspeed shutdown
- Loss of speed signal shutdown
- genset over Voltage shutdown
- genset over Current shutdown
- Failed to start
- Over freq Shutdown
- Temp Sensor Open
- Oil sensor open
- Input Shutdown
- Over Power
- Low water sensor
Going Fully Automatic
All of our generators are partnered with a Smartgen 6120 controller system this gives the user the option of going fully automatic.
To go fully automatic add ATS & AMF HAT520 Transfer box depending on the size your electrician would only need to run the wiring between the generator, transfer box and the main switchboard. And when you lose power the generator would auto start and when the power returns the generator would auto shutdown. Note: The Transfer Box is not waterproof
To go fully automatic add ATS & AMF HAT520 Transfer box depending on the size your electrician would only need to run the wiring between the generator, transfer box and the main switchboard. And when you lose power the generator would auto start and when the power returns the generator would auto shutdown. Note: The Transfer Box is not waterproof